Remove/Install Compressed Air Reservoir For Multicontour Seat - AR91.25-P-1571MEM

Model 167.9 

with code 406 (Multicontour rear seat) 

With Code M036 (Maybach Version) 

Courtesy of MERCEDES-BENZ USA

Shown with code 308 (Refrigeration compartment in rear) 

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Notes on HANDS-FREE ACCESS		AH80.61-P-0001-01A
	Remove/install
1	Remove refrigerator box (1) in load compartment.	Model 167.9 with code 308 (Refrigerated compartment in rear passenger compartment) with code 406 (Multicontour rear seat) with code M036 (Maybach version)	AR86.61-P-1010MEX
2	Unclip front load compartment floor (2) and remove from vehicle.	Long wedge	Fig 1
3	Remove screws from hinges of rear load compartment floor (3) and remove rear load compartment floor (3) from vehicle.	Screw, rear load compartment floor to crossmember	*BA68.30-P-1003-01G
4	Remove rear-end center-section trim (4).		AR68.30-P-4786ME
5	Remove stowage tray from load compartment.
6	Remove compressed-air lines (5) from compressed-air reservoir (6).	Note installation position of compressed-air lines (5).
7	Remove terminal strips (7) from crossmember and remove compressed-air reservoir (6) with holder (8) from vehicle.
8	Install in the reverse order.

Fig 1: Identifying Long Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ USA