Remove/Install License Plate Lamps - AR82.10-P-5161ME
Model 167.1/9
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notes on HANDS-FREE ACCESS | AH80.61-P-0001-01A | ||
| Remove/install | |||
| 1 | Switch off ignition and store transmitter key outside of transmitter range (min. 2 m). | ||
| 2 | Remove center liftgate trim. | AR72.20-P-6618ME | |
| 3 | Release and disconnect electrical connector from left license plate lamp (E19/1) or right license plate lamp (E19/2). | ||
| 4 | Unclip left license plate lamp (E19/1) or right license plate lamp (E19/2) (arrows). | ||
| 5 | Install in the reverse order. |