Remove/Install Rear Shelf - AR68.30-P-4581MEX

Model 167.9 

With Code M036 (Maybach version) 

Courtesy of MERCEDES-BENZ USA

Shown on the left side of vehicle 

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Notes on HANDS-FREE ACCESS		AH80.61-P-0001-01A
	Remove/install
1	Remove left and right side load compartment trim.		AR68.30-P-1185MEM
2	Remove expansion rivets (1) and lower trim (2) until electrical connectors of load compartment lamps (E18/4, E18/5) can be accessed.	Dismantling tool	Fig 1
3	Disconnect electrical connectors of load compartment lamps (E18/4, E18/5) and remove trim (2).
4	Mark position of screws (3, 5).
5	Remove screws (3) and remove angle pieces (4).	Align screws (3) with markings.
6	Remove bolts (5).	Align screws (5) with markings.
7	Unhook cables of rear shelf (6) at tailgate.
8	Release rear shelf (6) at left and right from below (arrow), fold downward, and remove from vehicle.
9	Install in the reverse order.

Fig 1: Identifying Dismantling Tool (000 589 95 63 00)

Courtesy of MERCEDES-BENZ USA