Remove/Install Taillamp Unit On Liftgate - AR82.10-P-4926ME

Model 167 

Fig 1: Left/Right Rear Inner Taillamp Unit On Liftgate Components Location - Model 167

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
Topical note	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Notes on HANDS-FREE ACCESS		AH80.61-P-0001-01A
	Remove/install
1	Switch off ignition and store transmitter key outside of transmitter range (min. 2 m).
2	Remove center liftgate trim.		AR72.20-P-6618ME
3	Release and disconnect electrical connector at inner left rear lamp unit (E3/1) or inner right rear lamp unit (E4/1).
4	Unfasten nut (1).	The nut (1) remains on the inner rear lamp unit (E3/1 or E4/1).
5	Remove inner left rear lamp unit (E3/1) or inner right rear lamp unit (E4/1).
	Check
6	Check seal of rear lamp unit (E3/1 or E4/1) for damage.	If the seal of the rear lamp unit (E3/1 or E4/1) is damaged. ↓ Replace seal.
7	Install in the reverse order.