Remove/Install Right Circulation Pump For Low Temperature Circuit - AR09.41-P-6931MRK
Engine 264 In Model 167
Fig 1: Right Circulation Pump For Low Temperature Circuit Components Location - Engine 264 In Model 167
| Risk of injury to skin and eyes suffering scalding from contact with hot coolantspray. Risk of poisoning from swallowing coolant. | Do not open cooling system unless coolant temperature is below 90°C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers. Wear protective gloves, protective clothing and safety glasses. | AS20.00-Z-0001-01A | |
| Topical note | Notes on avoiding damage through contamination and foreign objects | AH00.00-P-5000-01A | |
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Remove/install | |||
| 1 | Switch off ignition and store transmitter key outside of transmitter range (min. 2 m). | ||
| 2 | Drain coolant of low-temperature circuit. | AR09.41-P-6834MRK | |
| 3 | Remove front section of the fender liner in the front right fender. | AR88.10-P-1301ME | |
| 4 | Release and disconnect electrical connections (1). | ||
| 5 | Remove coolant hoses (2, 3) from low-temperature circuit circulation pump 1 (M43/6). | AR20.20-P-7441-01RQ | |
| 6 | Secure low-temperature circuit circulation pump 1 (M43/6) against falling down and remove screw (4). | ||
| 7 | Remove low-temperature circuit circulation pump 1 (M43/6). | ||
| 8 | Install in the reverse order |