Remove/Install Upper Side Load Compartment Trim - AR68.30-P-1186MEC

Model 167.3 

Shown on the right side of the vehicle with code 811 (Advanced Sound System) 

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
Topical note	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Notes on HANDS-FREE ACCESS		AH80.61-P-0001-01A
	Remove/install
1	Remove seat cushion in rear passenger compartment.		AR91.12-P-1021ME
2	Remove screw (3) and remove seat belt end fitting of the rear passenger compartment seat belt (4).	Ensure that the seat belt end fitting is positioned correctly on the rear-end floor.
		Bolt, rear belt end fitting	*BA91.40-P-1005-01U
3	Release load compartment trim (2) in the front area.		AR68.30-P-1185MEC
		The top load compartment trim (1) is hooked in the front area into the load compartment trim (2) (arrow A).
4	Unclip top load compartment trim (1) (arrows B).
5	Disconnect electrical connector (5).	Model 167.3 with code 810 (Sound system) Model 167.3 with code 811 (Advanced sound system)
6	Disconnect electrical connector from the right load compartment lamp (E18/4) or from the left load compartment lamp (E18/5).
7	Guide rear passenger compartment seat belt (4) through the top load compartment trim (1) and remove top load compartment trim (1) from the vehicle.
8	Remove speakers and the electrical wiring harness from the top load compartment trim (1).	Model 167.3 with code 810 (Sound system) Model 167.3 with code 811 (Advanced sound system) When installing a new top load compartment trim (1).
9	Remove right load compartment lamp (E18/4) or left load compartment lamp (E18/5) from the top load compartment trim (1).	When installing a new top load compartment trim (1).
10	Install in the reverse order.