Roof Paneling Adhesive Material Handling For Installation Notes - Ah65.10-P-1000-02A
Model all (smart)
The bonding surfaces should be free of dust, oil, grease, wax, dirt and other adhesive components or dirt residues. Wear cotton gloves.
Otherwise the adhesive force of the adhesive material starts to decrease.
Allow primer to flash off for at least 10 min.
Otherwise the adhesive force of the adhesive material starts to decrease.
Position the roof paneling onto the body flange within a period of 10 minutes.
Otherwise the adhesive force of the adhesive material starts to decrease.
If new parts were installed during a body repair, mask off bonding surfaces before painting.
Otherwise the adhesive force of the adhesive material starts to decrease.
Adhesive material may only be applied only to existing beads of glue that have been cut down, or to the original factory primer or repair primer approved by Daimler.
Use only primer filler approved by Daimler AG: https://xentryportaLi.daimler.com
Otherwise the adhesive force of the adhesive material starts to decrease.
The object and room temperature should be min. 15°C and should not exceed 35°C.
Otherwise the adhesive force of the adhesive material starts to decrease.
Before starting work, all components, materials and tools must be prepared for installation.
Otherwise the adhesive force of the adhesive material starts to decrease.
Observe following information at all times.
Otherwise, reliable and correct bonding cannot be assured because it is not possible.
- Use the repair kit specified in the EPC.
- Note all the adhesive manufacturer's instructions.
- The single-component adhesive can be processed when cold, it does not need to be pre-heated.
- The two-component adhesive can be processed when warm, it does not need to be pre-heated. Preheating is performed using a commercially available warm-up device.
- Shake primer before use for at least 1 min.
- The primer may not be applied to the old adhesive bead residue. Primer may only be applied to new roof paneling or a bodyshell surface not yet primed.
- Apply single thin coating of primer all-over, without extended wiping.
- If the repair area has been primed, apply the primer only after the primer has dried.
- The application nozzle included must be used and it may not be modified. The application nozzle generates a functional adhesive bead at a height of approx. 13 mm.
- The width of the adhesive bead must be at least two thirds of the width of the adhesive bead markings on the component parts to be bonded.