Blind Spot Assist Wiring Diagram - PE54.71-P-2100-97NCA
Model 167 with code 234 (Blind Spot Assist) Radar sensors B92/6, B92/11
| Code: | Designation: | Position: |
|---|---|---|
| A0 | Use of wiring diagrams | 40L |
| B92/11 | Left outer rear integrated radar sensor | 24A |
| B92/11 | Left outer rear integrated radar sensor | 2A |
| B92/11 | Left outer rear integrated radar sensor | 37J |
| B92/11 | Left outer rear integrated radar sensor | 37A |
| B92/11 | Left outer rear integrated radar sensor | 10A |
| B92/6 | Right outer rear integrated radar sensor | 13A |
| B92/6 | Right outer rear integrated radar sensor | 24A |
| B92/6 | Right outer rear integrated radar sensor | 37G |
| B92/6 | Right outer rear integrated radar sensor | 37A |
| B92/6 | Right outer rear integrated radar sensor | 19A |
| CAN PER | Peripherals CAN | 8K |
| Code 802 | YoM 21/1 | 2F |
| Code 802 | YoM 21/1 | 2G |
| N10/8 | Rear central control unit | 4L |
| W29/8 | Left D-pillar ground point | 6E |
| W29/9 | Right D-pillar ground point | 17E |
| X30/27 | Peripherals CAN (CAN PER) potential distributor electrical connector | 8L |
| Z36/17z1 | Rear sensor CAN (low) connector sleeve | 8G |
| Z36/19z1 | Rear sensor CAN (high) connector sleeve | 7G |
| Z36/35z1 | Rear radar sensors sensor power supply connector sleeve | 4F |
| Z36/64z1 | Rear Blind Spot Assist power supply end sleeve | 4G |