Remove/Install Rear Stabilizer Bar - AR32.35-P-2210ME
Model 167
Except Code 489 (AIRMATIC Dual Control/semi-active air suspension)
Except Code 490 (Electrohydraulic suspension)
Model 167
With Code 489 (AIRMATIC Dual Control/semi-active air suspension)
Except Code 490 (Electrohydraulic suspension)
| Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | AS00.00-Z-0002-01A | |
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Notes on threaded connections fastened using a tightening angle-based tightening process | AH00.00-P-0020-01A | ||
| Notice | Notes on self-locking nuts and bolts | AH00.00-P-0001-01KOA | |
| Notice | Evaluation of elastomer bearings | AH00.10-P-0001-01A | |
| Notes on repair work on suspension components | AH00.00-P-0100-01A | ||
| Remove/install | |||
| 1 | Switch off ignition and store transmitter key outside of transmitter range (min. 2 m). | ||
| 2 | Remove rear wheel and tire assemblies. | AR40.10-P-1102ME | |
| 3 | Remove left and right torsion bar linkages at stabilizer bar (2). | AR32.35-P-3329ME | |
| 4 | Unscrew screws (3) and remove holders (1). | except code 465 (Electric Active Roll Stabilization (EARS)) except code 489 (AIRMATIC Dual Control/semi-active air suspension) except code 490 (Electrohydraulic suspension) Model 167 with code 465 (Electric Active Roll Stabilization (EARS)) with code 489 (AIRMATIC Dual Control/semi-active air suspension) except code 490 (Electrohydraulic suspension) Screw, stabilizer holder to rear axle carrier |
*BA32.35-P-1001-03E |
| 5 | Remove stabilizer bar (2). | ||
| Check | |||
| 6 | Check stabilizer bar (2) and elastomer bearings (4). | If there is a problem, ↓ replace corresponding component part. |
|
| 7 | Install in the reverse order. |
REAR AXLE STABILIZER BAR
| Number | Designation | Model 167 except code 465 (Electric Active Roll Stabilization (EARS)) except code 489 (AIRMATIC Dual Control/semi-active air suspension) | Model 167 with code 465 (Electric Active Roll Stabilization (EARS)) with code 489 (AIRMATIC Dual Control/semi-active air suspension) | ||
|---|---|---|---|---|---|
| BA32.35-P-1001-03E | Screw, stabilizer holder to rear axle carrier | Stage 1 | Nm | 100 | 100 |
| Stage 2 | ∠° | - | 45 | ||