Remove/Install Liftgate Wiper Motor - AR82.30-P-6550ME
Model 167.1/9
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notes on HANDS-FREE ACCESS | AH80.61-P-0001-01A | ||
| Remove/install | |||
| 1 | Remove liftgate wiper arm. | AR82.30-P-6911ME | |
| 2 | Remove center liftgate trim. | AR72.20-P-6618ME | |
| 3 | Release electrical connector (1) and disconnect. | ||
| 4 | Unscrew bolts (2). | *BA82.30-P-1005-01R | |
| 5 | Remove liftgate wiper motor (M6/4). | ||
| Check | |||
| 6 | Check grommet (3) for damage. | If damage is present, ↓ Replace grommet (3). |
|
| 7 | Install in the reverse order. |
WINDSHIELD WIPER
| Number | Designation | Model 167 | |
|---|---|---|---|
| BA82.30-P-1005-01R | Screw/bolt, wiper motor to liftgate | Nm | 8 |