Remove/Install Drive Cable For Panoramic Sunroof Roller Sun Blind - AR77.21-P-0230MFA

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.

Model 118, 177

with code 413 (Automatic panoramic sliding sunroof)

Courtesy of MERCEDES-BENZ USA

Shown on model 177.0 with code 413 (panoramic sliding sunroof) on the left-hand side of the vehicle

Courtesy of MERCEDES-BENZ USA

	Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Remove/install
1	Remove roller sunblind from panoramic sliding sunroof.		AR77.21-P-0215MFA
2	Remove panoramic sliding sunroof roller sunblind drive unit (M12/5).		AR77.21-P-0493MFA
3	Remove screw/bolt (1).	The instructions are shown only for one side and must be carried out on both sides.
4	Remove screw/bolts (2).	The instructions are shown only for one side and must be carried out on both sides.
5	Lift guide rail (3) and pull with drive cable in direction of rear area.	The instructions are shown only for one side and must be carried out on both sides. Do not pull suddenly, as drive cable of roller sunblind is still connected with guide rail (3).
6	Remove slide shoe (4) with drive cable for roller sunblind from guide rail (3).	The instructions are shown only for one side and must be carried out on both sides.
7	Install in the reverse order.