Remove/Install Oil Feed Line For Turbocharger - AR09.40-P-6022MFG
Engine 139 in model 118, 177, 247
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Risk of injury to skin and eyes due to handling of engine oil. Risk of poisoning caused by swallowing engine oil | Wear protective gloves, protective clothing and safety glasses. Do not fill engine oil into beverage containers. |
AS18.00-Z-0001-01A | |
| Notice | Notes on avoiding damage through contamination and foreign objects | AH00.00-P-5000-01A | |
| Remove/install | |||
| 1 | Unscrew screws (1) and remove heat shield (2). | ||
| 2 | Remove upper engine cover. | ||
| AP01.10-P-2405-01K | |||
| 3 | Unscrew bolt (4). | *BA09.40-P-1003-01X | |
| 4 | Remove oil feed line (3) from exhaust gas turbocharger and seal exposed openings with suitable stop plugs. | ||
| Fig 1 | |||
| 5 | Place electric line (5) to one side and remove screw (6). | *BA09.40-P-1003-01X | |
| 6 | Remove oil feed line (3) from cylinder head cover and seal exposed openings with suitable stop plugs. | ||
| Fig 1 | |||
| 7 | Remove oil feed line (3). | ||
| 8 | Install in the reverse order. | ||
| Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | AS00.00-Z-0005-01A | |
| 9 | Perform engine test run. While doing so, check engine for proper operation and leak tightness. | ||
| 10 | Install upper engine cover. | Engine 139 in model 118, 177, 247 | |
| Engine 139 in model 118, 177 | AP01.10-P-2405-01K |
TURBOCHARGER
| Number | Designation | Engine 139 | |
|---|---|---|---|
| BA09.40-P-1003-01X | Screw, oil feed line to exhaust gas turbocharger/crankcase/cylinder head cover/holder | Nm | 8 |