Remove/Install Front Panoramic Roof Roller Sun Blind - AR77.21-P-0200MFB

Model 243, 247 

with code 413 (Panoramic sliding sunroof/glass roof) 

Courtesy of MERCEDES-BENZ USA

Shown on right side of vehicle 

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Remove/install
1	Remove sliding roof panel.		AR77.20-P-2854MFA
2	Detach seal (2) in the area of the roller sunblind (1) from the guide rail.
3	Detach seal (3) from the panorama roof frame.
4	Unscrew bolt (4).
5	Position roller sunblind (1) so that bores (arrow) of sliding shoe (6) and roller sunblind bearing bushing (7) match, and secure with a suitable safety pin.	If roller sunblind (1) is to be used again.
6	Press catch hook (5) toward the front (arrow A) using a suitable tool, lift sliding shoe (6), (arrow B) and move out.	: Ensure that the sliding shoes (6) are seated correctly. Otherwise, the function of the roller sunblind (1) is not ensured. : Remove safety pins before installing roller sunblind (1). Otherwise, the roller sun blind (1) will be damaged during actuation.
7	Remove roller sunblind (1).
8	Install in the reverse order.