Press-In Propeller Shaft Pilot Bushing - AR41.10-P-0250-03MSA
Model 257
CHECK VALUES FOR PILOT BUSHING ON PROPELLER SHAFT
| Number | Designation | Model 257.318/320/358 | Model 257.321/323 Model 257.359 2# except code 460 (Canada version) except code 494 (US version) | ||
|---|---|---|---|---|---|
| BE41.10-P-1001-04Q | Press-in dimension "a" from face end of pilot bushing to joint flange | Front propeller shaft | mm | 25, 30 | 24, 80 |
| Rear propeller shaft | mm | 28, 80 | 36, 30 | ||
CHECK VALUES FOR PILOT BUSHING ON PROPELLER SHAFT
| Number | Designation | Model 257.351 Model 257.359 1# except code 460 (Canada version) except code 494 (US version) | Model 257.359 with code 460 (Canada version) Model 257.359 with code 494 (US version) | ||
|---|---|---|---|---|---|
| BE41.10-P-1001-04Q | Press-in dimension "a" from face end of pilot bushing to joint flange | Front propeller shaft | mm | 23, 30 | 23, 30 |
| Rear propeller shaft | mm | 26, 80 | 34, 80 | ||
- Press in new pilot bushing using a suitable drift. Model 257
Observe the pressing-in dimension (a) from the front of the pilot bushing to the flange. The specified press-in distance (a) may deviate depending on the thickness of the flexible couplings, e.g. in vehicles with vibration damper. In these cases the dimension (a) measured prior to removal should be used for installation.