Remove/Install Rear Shock Absorber - AR32.25-P-0110MFA
Model 118, 177, 243, 247
Shown on model 177 with code U54 (Torsion-beam axle) on left side of vehicle
Shown on model 177 with code U54 (Torsion-beam axle) on left side of vehicle
Shown on model 177 with code 459 (Steel suspension with adjustable damping) on left side of vehicle
| Notice | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notice | Notes on self-locking nuts and bolts | AH00.00-P-0001-01KOA | |
| Notes on repair work on suspension components | AH00.00-P-0100-01A | ||
| Remove/install | |||
| 1 | Remove trim on left and right in trunk. | Model 177.0 | AR68.30-P-4800MFA |
| Model 243.7, 247.0/7 | AR68.30-P-4800MFB | ||
| Model 243.6, 247.6 | AR68.30-P-4801MFX | ||
| Model 118.3, 177.1/9 | AR68.30-P-4800MFV | ||
| Model 118.6 | AR68.30-P-4800MFD | ||
| 2 | Release and disconnect electrical connector (5). | Model 118, 177, 247 with code 459 (Steel suspension with adjustable damping) Model 243 with code 457 (Comfort suspension with adjustable damping) |
|
| 3 | Remove grommet (6) from body and expose electrical wiring harness. | Model 118, 177, 247 with code 459 (Steel suspension with adjustable damping) Model 243 with code 457 (Comfort suspension with adjustable damping) |
|
| 4 | Remove nuts (4). | *BA32.25-P-1002-03R | |
| 5 | Raise vehicle with vehicle lift. | AR00.60-P-1006A | |
| 6 | Remove nuts (7). | Model 118, 177, 247 with code 459 (Steel suspension with adjustable damping) Model 243 with code 457 (Comfort suspension with adjustable damping) |
|
| 7 | Remove cover at lower spring link. | Model 118, 177, 243, 247 with code U55 (Multi-link axle) |
|
| 8 | Support axle using telescopic lifter. | ||
| 000 588 23 62 00 Mounting plate | WS26.00-P-0415B | ||
| 000 588 24 62 00 Major assembly mount | WS01.00-P-0253B | ||
| 9 | Counterhold nut (3) and unscrew screw (2). | *BA32.25-P-1001-03R | |
| 10 | Remove left or right shock absorber (1). | ||
| Check | |||
| 11 | Check shock absorber (1) at left or right for damage. | If there is a problem, ↓ replace left and right shock absorber (1). |
AR32.25-P-0121MFA |
| 12 | Install in the reverse order. |
REAR AXLE SHOCK ABSORBER
| Number | Designation | Model 118, 177, 243, 247 | ||
|---|---|---|---|---|
| BA32.25-P-1001-03R | Nut, shock absorber to rear axle/spring link | M10 | Nm | 50 |
REAR AXLE SHOCK ABSORBER
| Number | Designation | Model 118, 177, 243, 247 | ||
|---|---|---|---|---|
| BA32.25-P-1002-03R | Nut, shock absorber to body | M10 | Nm | 50 |