Check All Visible Parts Of Vehicle Underside For Damage And Fluid Loss - AP00.20-P-0054N

Model 118, 177, 247 

Courtesy of MERCEDES-BENZ USA

Shown on model 177.045 

Courtesy of MERCEDES-BENZ USA

Shown on model 177.053 

	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
	Risk of injury  . Skin or eye injuries may result when handling hot or glowing objects.	Wear protective gloves, protective clothing and safety glasses, if necessary.	AS00.00-Z-0002-01A
	Risk of injury  from engine start by remote start function	Prior to starting work, open engine hood, do not reach into rotation range or hazard area of freely rotating parts, wear closed and snug-fitting work clothes	AS00.00-Z-0024-01A
	Risk of injury  due to fan starting unexpectedly	Do not reach into the rotation or hazard area of the fan. Wear closed and close-fitting work clothes.	AS20.40-Z-0001-01A
	Risk of injury  caused by scraping or cutting body parts on sharp vehicle parts	Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels.	AS00.00-Z-0017-01A
Notice	General information on vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system as well as personal protective equipment		AH00.00-Z-0300-01A
Notice	Notes on battery		AH54.10-P-0001-01A
	Notes on evaluating leakages		AH00.00-P-0011-01KOA
	Preparatory tasks
1	Lift vehicle with vehicle lift.
			AR00.60-P-1006A
	Check
2	Check underfloor paneling for damage from driving over obstacles or from bottoming damage.	If necessary, use commercially available devices/tools.  Swiveling inspection mirror with lighting, comparable to inspection mirror Hazet 1977-1 If it is suspected that there is damage from driving over obstacles or bottoming, ↓ Check front axle steering for mechanical damage. If the front axle steering is mechanically damaged, ↓ replace front axle steering for safety reasons. After obtaining special order.
	Remove
3	Remove lower engine compartment lining (1).
		Model 118, 177, 247 with engine 260 except code M016 (Uprated engine) Model 118, 177, 247 with engine 282	AR61.20-P-1105MFA
		Model 118, 177, 247 with engine 260 with code M016 (Uprated engine) Model 118, 177, 247.7 with engine 139	AR61.20-P-1105MFR
		Model 118, 177, 247 with engine 608Model 247 with engine 654	AR61.20-P-1105MFE
4	Remove lower front engine compartment lining (2).	Model 118, 177, 247 with engine 139
	Check
5	Check visible systems, component parts, lines and hoses of the drive train on the underfloor for damage, correct routing, fluid loss, correct mounting and corrosion.	If necessary, use commercially available devices/tools.  Swiveling inspection mirror with lighting, comparable to inspection mirror Hazet 1977-1 Brake system, Spring elements, Shock absorber, Suspension lines and sensors, Steering, Front axle, Front axle shafts with boots, Engine and mounted major assemblies, Cooling system, Heater and A/C system, Exhaust system, Exhaust aftertreatment, Actuator motors of exhaust gas flaps, Heat shields, Rear axle, Fuel system. If problems are determined, ↓ rectify the problems. After obtaining special order.
6	Check visible systems, component parts, lines and hoses on the underfloor for damage, correct routing, fluid loss, correct mounting and corrosion.	Equipment-dependent. If necessary, use commercially available devices/tools.  Swiveling inspection mirror with lighting, comparable to inspection mirror Hazet 1977-1 External noise sound generator, Hybrid components, Inerting system, Stationary heater, Manual transmission, Clutch operation, Automatic transmission, Transfer case (4MATIC), Rear axle differential (4MATIC), Rear axle shafts with boots (4MATIC). If problems are determined, ↓ rectify the problems. After obtaining special order.
7	Check underfloor and visible component parts on underfloor for damage, routing, mounting and corrosion.	If necessary, use commercially available devices/tools.  Swiveling inspection mirror with lighting, comparable to inspection mirror Hazet 1977-1 Wheel well trim Underfloor paneling, Underfloor. If problems are determined, ↓ rectify the problems. After obtaining special order.
8	Check visible body panels for corrosion and deformation.	If necessary, use commercially available devices/tools.  Swiveling inspection mirror with lighting, comparable to inspection mirror Hazet 1977-1 Wheel well body panels, Front axle carrier, Rear axle carrier, Chassis steering arms, Underfloor body panels, Body reinforcements. If problems are determined, ↓ proceed in accordance with the country-specific regulations for mobility and body shell complaints. After obtaining special order.
	Install
9	Install lower front engine compartment lining (2).	Model 118, 177, 247 with engine 139
10	Install engine compartment lining at bottom (1).
		Model 118, 177, 247 with engine 260 except code M016 (Uprated engine) Model 118, 177, 247 with engine 282	AR61.20-P-1105MFA
		Model 118, 177, 247 with engine 260 with code M016 (Uprated engine) Model 118, 177, 247.7 with engine 139	AR61.20-P-1105MFR
		Model 118, 177, 247 with engine 608Model 247 with engine 654	AR61.20-P-1105MFE