Remove/Install Heat Shield On Exhaust Gas Turbocharger - AR09.40-P-6045MFC
Engine 260 in model 118, 177, 247
Shown on model 177 with engine 260 except code M016 (Performance-enhanced engine) up to model year 2022
Shown on model 177 with engine 260 except code M016 (Performance-enhanced engine) up to model year 2022
| Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | AS00.00-Z-0002-01A | |
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Remove/install | |||
| 1 | Remove oxygen sensor upstream of catalytic converter. | AR07.04-P-0086MFC | |
| 2 | Remove the inerting system line in the engine compartment and place to one side. | Engine 260 in model 118, 177, 247 with code 2U8 (Alternative refrigerant) | AR86.10-P-0119MFC |
| 3 | Remove charge air pipe downstream of exhaust gas turbocharger. | Engine 260 in model 118, 177, 247 with code M016 (Uprated engine) | AR09.41-P-1333MFC |
| 4 | Remove engine air intake duct downstream of air filter. | Engine 260 in model 118, 177, 247 up to model year 2022 with code M016 (Uprated engine) | AR09.10-P-8130MFC |
| 5 | Remove screws (2) | *BA09.40-P-1008-02G | |
| 6 | Remove the front heat shield (1) from the retaining clips (3). | ||
| 7 | Unscrew screw (6), and release upper heat shield (4) from retaining clamps (3) and remove. | Engine 260 in model 118, 177, 247 up to model year 2022 |
|
| *BA09.40-P-1008-02G | |||
| 8 | Install in the reverse order. |
TURBOCHARGER
| Number | Designation | Engine 260 | |
|---|---|---|---|
| BA09.40-P-1008-02G | Bolt, heat shield to cylinder head/holder/support | Nm | 10 |