New Parts On Main Floor Panel Prepare For Installation - Ar63.40-P-1180-23MFA

Model 118.3/6 

Model 177.0/1/9 

Model 247.0/6/7 

Additional information can be found in the superordinate service document.

The safety information in the superordinate service document must be observed.

Courtesy of MERCEDES-BENZ USA

1. Mark cut point on main floor (1) and disconnect (area G₁ ).

   

   Transfer separation point from vehicle.

2. Mark corner in main floor (1) (areas G_2a and G_3a ).

   

   Transfer separation point from vehicle.

   Courtesy of MERCEDES-BENZ USA

3. Mark corner in main floor (1) (areas G_2b and G_3b ).

   Dimensions:

   f = approx. 20 mm

4. Disconnect corner in the main floor (1) (areas G_2b and G_3b )^.

   Courtesy of MERCEDES-BENZ USA

   Courtesy of MERCEDES-BENZ USA

5. Grind main floor (1) down to bare metal in the cross-hatched areas.
6. Remove grinding dust.
7. Coat cross-hatched areas with zinc dust paint.

   Do not coat bonding surfacers with zinc dust paint (area I).

   Otherwise adhesion problems can occur.

   

   Observe pretreatment of bonding surfaces.