Inner C-Pillar Side Wall Preparation - Ar63.10-P-0700-02MFC
Model 118.3
REPAIR MATERIALS
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1056-07A | 1K-zinc dust paint | A 000 986 28 00 |
The following steps are shown on the left side of the vehicle and must be performed analogously on the right side in the event of damage.
The superordinate service document as well as the safety information in the service document must be observed.
- Mark separating point on C-pillar side wall (1) and separate (area M).
Transfer separation point from vehicle.
- Grind mating surfaces on C-pillar side wall (1) down to bare metal in crosshatched areas.
Sand down spot weld flanges to bare metal on both sides.
- Remove grinding dust.
- Coat insides of spot weld flanges with zinc dust paint.
Do not coat bonding surfaces with zinc dust paint (areas N).
Otherwise adhesion problems can occur.
Observe pretreatment of bonding surfaces.
- Mark separating point on reinforcement (2) and separate (area O).
Transfer separation point from vehicle.
- Grind mating surfaces on reinforcement (2) down to bare metal in cross-hatched areas.
Sand down spot weld flanges to bare metal on both sides.
- Remove grinding dust.
- Apply zinc dust paint to insides of spot weld flanges.
Otherwise adhesion problems can occur.
Observe pretreatment of bonding surfaces.