Remove/Put On Wheel Hub - Ar35.20-D-0310-04TSR

Model 907 with rear axle 741.422/453/454/455/456

HUB

Number	Designation		Rear axle 741.422/453/454/45 5/456
BA35.20-N-1001-06C	Inner slotted nut, wheel hub to axle tube	Nm	300

HUB

Number	Designation		Rear axle 741.422/453/454/45 5/456
BA35.20-N-1002-06C	Outer slotted nut, wheel hub to axle tube	Nm	250

Fig 1: Claw-Type Wrench (906 589 00 07 00)

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1017-06A	MB multipurpose grease, 400 g	A 001 989 34 51 11

Bend up locking plate (1).
Unscrew slotted nut (2) using the US claw wrench.
Remove locking plate (1).
Unscrew slotted nut (2) using the claw wrench.
Remove thrust plate (3).
Remove wheel hub (4) with wheel bearing (5).
Mount wheel hub (4) onto axle tube.
Check wheel bearing (5) for damage.
If the wheel bearing (5) is damaged,

↓

replace wheel bearing (5).
Insert the wheel bearing (5).
Apply grease to wheel bearing (5).
Put on thrust plate (3).
Check thrust plate (3) for damage.

If thrust plate (3) is damaged,

↓

replace thrust plate (3).
Tighten slotted nut (2) using the claw wrench
While doing so, continuously turn wheel hub (4).
Release slotted nut (2) using the claw wrench.
Adjust slotted nut (2) using the claw wrench.
To do so, tighten the slotted nut (2) until thrust plate (3) has zero clearance. Then turn the slotted nut (2) back by 1/8th of a turn.
Fit locking plate (1).
Replace locking plate (1).
Tighten slotted nijt_(2) using the claw wrench .
Move lock washer (1).