Remove/Install Lower Steering Shaft - Ar46.10-D-7310TS
Model 907
Shown on model 907
Shown on model 910
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| Notes on self-locking nuts and bolts | AH00.00-N-0001-01A | ||
| Evaluating steering gear when repairing accident vehicles | AH46.20-P-9409-01A | ||
| Remove/install | |||
| 1 | Fix steering wheel in center position. | AR46.20-D-0500-01TS | |
| Notes on carrying out repair work in the vehicle interior | AH68.00-N-0001-01S | ||
| Fig 1 | |||
| Fig 2 | |||
| 2 | Remove bolt (2). | *BA46.10-N-1004-05TS | |
| 3 | Remove steering shaft (1) from universal joint (3). | ||
| 4 | Raise vehicle. | AR00.60-D-1000-04TS | |
| Special instructions for lifting and supporting vehicle | AH00.60-N-0100-01TS | ||
| 5 | Remove engine compartment lining. | If installed. | |
| AR61.20-D-1105TS | |||
| 6 | Remove screw (9). | *BA46.10-N-1001-05TS | |
| 7 | Remove universal joint (7) from steering gear. | Otherwise the screw (9) cannot be screwed in correctly. The shown direction of installation of the screw (9) must be observed. Otherwise malfunctions and damage may occur due to an incorrectly fastened universal joint (7). wsm://04 201900 68 Depiction of operation steps 6, 7 |
|
| 8 | Remove steering shaft (1). | ||
| 9 | Install in the reverse order. |
| Number | Designation | Model 907 | |
|---|---|---|---|
| BA46.10-N-1001-05TS | Screw, lower steering shaft to steering gear | Nm | 28 |
| Number | Designation | Model 907 | |
|---|---|---|---|
| BA46.10-N-1004-05TS | Screw, steering shaft to steering shaft bearing | Nm | 28 |