Remove/Install D-Pillar Trim - Ar68.30-D-4497TSR
Model 907.6/7/8
Shown on model 907.7
Shown on model 907.7
| Notes on carrying out repair work in the vehicle interior | AH68.00-N-0001-01S | ||
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1 | Remove left or right grab handle from D-pillar. | Model 907.6/7 with code T85 (Entrance handle on LH rear corner pillar) Model 907.6/7 with code T86 (Entrance handle on RH rear corner pillar) |
|
| 2 | Remove expansion rivets (2). | ||
| 3 | Unclip D-pillar trim (1) from top to bottom until electrical connector (3) is accessible. | If installed. | |
| Fig 1 | |||
| 4 | Disconnect electrical connector (3) from 12 V socket (5) and remove D-pillar trim (1) to the rear. | If installed. | |
| 5 | Remove 12 V socket (5) from D-pillar trim (1). | If installed when installing new D-pillar trim (1) | AR54.10-D-1009TS |
| Check | |||
| 6 | Check retaining clips (4) for damage and correct seating. | If a retaining clip (4) is not correctly positioned in mount on D-pillar trim (1), ↓ Correctly position retaining clip (4). If a retaining clip (4) is damaged, ↓ Replace retaining clip (4). |
|
| 7 | Install in the reverse order | ||
| Check | |||
| 8 | Perform function test of the 12 V socket (5). | If installed. |