Assignment Of Relay Holders On Seat Base - GF54.15-D-1257-12TSA
Model 907
MODEL 907
| Relay slot | Relay function | Pin | Circuit | Wire Identification | Function |
|---|---|---|---|---|---|
| 15 | Right rear window wiper | 1 | 87 | 1.5 RDVT | Fuse block 1, 9-pin (F55/1) |
| 2 | 85 | 0.5 WHBK | SAM control unit (N10) | ||
| 3 | 87a | 1.5 BN | Driver's seat base ground point 2 (W105/2) | ||
| 4 | 86 | 0.5 BN | Driver's seat base ground point 2 (W105/2) | ||
| 5 | 30 | 1.5 BKVT | Right rear-end door electrical connector 2 (X8/50x2) | ||
| 16 | Body manufacturer terminal strip | 1 | 87 | 0.75 BKRD | Body manufacturer electrical connector 1 (X145/1x1) |
| 2 | 85 | 0.5 WHGN | SAM control unit (N10) | ||
| 3 | 87a | NOT USED | NOT USED | ||
| 4 | 86 | 0.5 BN | Driver's seat base ground point 2 (W105/2) |
||
| 5 | 30 | 0.75 RDBK | Vehicle interior fuse and relay module (F152) | ||
| 17 | Backup warning system switch | 1 | 87 | 0.5 WHBU | Reverse warning device horn (H16/2) |
| 2 | 85 | 0.5 PKBK | Vehicle interior fuse and relay module (F152) | ||
| 3 | 87a | NOT USED | NOT USE | ||
| 4 | 86 | 0.5 BNBK | Right cockpit/MWH electrical connector 2 (X18/82x2) |
||
| 5 | 30 | 0.5 WHBU | Reversing light end sleeve (Z38/1) | ||
| 18 | Roof ventilator | 1 | 87 | 1 BKBU | Right cockpit/MWH electrical connector 4 (X18/82x4) |
| 2 | 85 | 0.5 BKWH | Fuse block 3, 9-pin (F55/3) | ||
| 3 | 87a | NOT USED | NOT USED | ||
| 4 | 86 | 0.5 BN | Driver's seat base ground point 2 (W105/2) |
||
| 5 | 30 | 1 RDVT | Vehicle interior fuse and relay module (F152) | ||
| 19 | Auxiliary oil pump | 1 | 87 | 1.5 RDVT | Auxiliary oil pump NAG2 (M42/7) |
| 2 | 85 | 0.5 BNGN | Terminal 15 end sleeve (relay actuation, low) (Z3/66) | ||
| 3 | 87a | NOT USED | NOT USED | ||
| 4 | 86 | 0.5 RDWH | Vehicle interior fuse and relay module (F152) | ||
| 5 | 30 | 1.5 RDBN | Fuse block 2, 9-pin (F55/2) | ||
| 20 | Right electric step 1 | 1 | 87 | 1 RDBK | Fuse block 5, 9-pin (F55/5) |
| 2 | 85 | 0.5 RDBU | Parameterizable special module (PSM) control unit (N26/15) | ||
| 3 | 87a | 1 BN | Driver's seat base ground point 2 (W105/2) | ||
| 4 | 86 | 0.5 BN | Driver's seat base ground point 2 (W105/2) | ||
| 5 | 30 | 1 BU | Right step end sleeve (Z254/2) | ||
| 21 | Right electric step 2 | 1 | 87 | 1 RDBN | Fuse block 5, 9-pin (F55/5) |
| 2 | 85 | 0.5 PNGN | Parameterizable special module (PSM) control unit (N26/15) | ||
| 3 | 87a | 1 BN | Driver's seat base ground point 2 (W105/2) | ||
| 4 | 86 | 0.5 BN | Driver's seat base ground point 2 (W105/2) | ||
| 5 | 30 | 1 GY | Right electric step (A106/2) | ||
| 22 | Left electric step 1 | 1 | 87 | 1 RDBU | Fuse block 5, 9-pin (F55/5) |
| 2 | 85 | 0.5 BNBK | Driver's seat base ground point 2 (W105/2) | ||
| 3 | 87a | 1 BN | Driver's seat base ground point 2 (W105/2) | ||
| 4 | 86 | 0.5 RDBU | Parameterizable special module (PSM) control unit (N26/15) | ||
| 5 | 30 | 1 GN | Left step end sleeve (Z254/1) | ||
| 23 | Left electric step 2 | 1 | 87 | 1 RDGY | Left electric step (A106/1) |
| 2 | 85 | 0.5 BNBU | Driver's seat base ground point 2 (W105/2) | ||
| 3 | 87a | 1 BN | Driver's seat base ground point 2 (W105/2) | ||
| 4 | 86 | 0.5 PKGN | Parameterizable special module (PSM) control unit (N26/15) | ||
| 5 | 30 | 1 VT | Left electric step (A106/1) | ||
| 24 | Tone sequence | 1 | 87 | 1.5 BKOG | Tone signal generator (A46) |
| 2 | 85 | 1 YERD | Rotating beacon with tone sequence terminal 84 end sleeve (Z47/18) | ||
| 3 | 87a | NOT USED | NOT USED | ||
| 4 | 86 | 0.75 BN | Driver's seat base ground point 2 (W105/2) | ||
| 5 | 30 | 1.5 RDBU | Fuse block 5, 9-fuse (F55/4) | ||
| 25 | Rotating beacon with tone sequence | 1 | 87 | 1.5 RDBK | Rotating beacon with tone sequence terminal 30 end sleeve (Z47/16) |
| 2 | 85 | 1 BKYE | Tone sequence diode (V22) | ||
| 3 | 87a | NOT USED | NOT USED | ||
| 4 | 86 | 0.75 BN | Driver's seat base ground point 2 (W105/2) | ||
| 5 | 30 | 1.5 YERD | Rotating beacon with tone sequence terminal 84 end sleeve (Z47/18) | ||
| 26 | Cargo lift gate | 1 | 87 | 0.75 BNGN | Cargo liftgate electrical connector 1 (X281x1) B2 |
| 2 | 85 | 0.75 BKVT | Cargo liftgate electrical connector 1 (X281x1) B5 | ||
| 3 | 87a | 0.75 BNYE | Cargo liftgate electrical connector 1 (X281x1) B3 | ||
| 4 | 86 | 0.75 BNWH | Cargo liftgate electrical connector 1 (X281x1) B6 | ||
| 5 | 30 | 0.75 BNBU | Right cockpit/MWH electrical connector 6 (X18/82x6) |