Remove/Install Lower A-Pillar Trim On Driver's Side - Ar68.30-D-0011TSR
Model 907
| Notes on carrying out repair work in the vehicle interior | AH68.00-N-0001-01S | ||
| Remove/install | |||
| 1 | Remove door sill molding (2) | AR68.30-D-1306TS | |
| 2 | Unclip engine hood cable handle (4) using a suitable screwdriver, and remove | ||
| 3 | Remove panel (3) | AR83.10-D-4719TS | |
| 4 | Fold back floor covering (10) and unscrew screw/bolt (6) | ||
| 5 | Remove expansion rivet (5) | ||
| 6 | Slide on locking element (8) in direction of arrow (arrow A) and pull the diagnostic connector (9) upwards out of the A-pillar trim at the bottom (1) | ||
| 7 | Lift door sill trim (7) in the front area slightly and remove A-pillar trim at bottom (1) | ||
| 8 | Remove bracket of diagnostic connector (9) | When replacing A-pillar trim at bottom (1). | |
| 9 | Install in the reverse order |