Retrofit Partition Between Driver's Cab And Load Compartment - An68.74-D-0652TS

Model 907.6 

with code D62 (Prov.f.retrofitting of partition) 

Shown with code T16 (Sliding door, right) 

Shown with code D03 (Roof and rear-end doors, high version) and code FF4 (Stowage compartment above roof lining) and code T16 (Sliding door, right) 

Shown with code D03 (Roof and rear-end doors, high version) and code T16 (Sliding door, right) except code FF4 (Stowage compartment above roof lining) 

Shown with code D03 (Roof and rear-end doors, high version) and code T16 (Sliding door, right) and code FF4 (Stowage compartment above roof lining) 

	Risk of injury  caused by scraping or cutting body parts on sharp vehicle parts	Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels.	AS00.00-Z-0017-01A
	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
	Notes on carrying out repair work in the vehicle interior		AH68.00-N-0001-01S
	Remove
1	Move driver's seat forward to topmost position
2.1	Move front passenger seat forward to topmost position.	Model 907.6 except code S23 (Two-seater front passenger seat)
2.2	Remove front passenger bench seat.	Model 907.6 with code S23 (Two-seater front passenger seat)
			AR91.10-D-1035TS
3	Remove tie-down eyes (12) in load compartment from B-pillars.	Model 907.6 except code P93 (Discontinuation of tie-down eyes) For this purpose, unscrew bolts of tie-down eyes (12).
4	Remove cover (13) at sliding door entrance.	Model 907.6 with code T16 (Sliding door, right) and/or code T19 (Sliding door, left) For this purpose, unscrews bolts of cover (13).
	Install
5.1	Install left section (2) on partition (1).	Model 907.6 with code T16 (Sliding door, right) except code D03 (Roof and rear-end doors, high version) except code FF4 (Stowage compartment above roof lining) except code T19 (Sliding door, left) Secure with nuts (4a).
5.2	Install right section (3) on partition (1).	Model 907.6 with code T19 (Sliding door, left) except code D03 (Roof and rear-end doors, high version) except code FF4 (Stowage compartment above roof lining) except code T16 (Sliding door, right) Secure with nuts (4b).
5.3	Install left section (2) and right section (3) on partition (1).	Model 907.6 with code D03 (Roof and rear-end doors, high version) with code FF4 (Stowage compartment above roof lining), model 907.6 except code D03 (Roof and rear-end doors, high version) except code T16 (Sliding door, right) except code T19 (Sliding door, left) Secure with nuts (4a, 4b).
5.4	Install left section (7), right section (8) and center section (9) on partition (1).	Model 907.6 with code D03 (Roof and rear-end doors, high version) except code FF4 (Stowage compartment above roof lining) Secure with nuts (4).
6	Retrofit partition (1).	Helper required. Otherwise, damage to the partition (1) or body may occur. For this purpose, guide partition (1) into vehicle and align.
7	Screw in bolts (6).	The required number of bolts (6) varies depending on the version.
8	Install tie-down eyes (12) on partition (1).	Model 907.6 except code P93 (Discontinuation of tie-down eyes)
		Screw, tie-down eye to B-pillar	*BA68.50-D-1001-03TS
9	Install cover (13) at sliding door entrance.	Model 907.6 with code T16 (Sliding door, right) and/or code T19 (Sliding door, left) For this purpose, screw in bolts of cover (13).
10	Move driver's seat to desired position.
11.1	Move front passenger seat to desired position.	Model 907.6 except code S23 (Two-seater front passenger seat)
11.2	Install front passenger bench seat.	Model 907.6 with code S23 (Two-seater front passenger seat)
			AR91.10-D-1035TS
12	Enter special equipment into online vehicle data card.	Designation of affected special equipment code D50 (Full-width partition wall) or code D51 (Full-width partition wall with 1 window). Delete existing code D62 (Pre-installation. f. retrofitting partition). Attach note "Partition retrofitted as per AN68.74-D-0652TS " under field organization texts in DG 68.
13	Perform SCN coding in front seat control unit.	Model 907.6 with code SF1 (Electrically adjustable driver's seat) except code SF2 (Electrically adjustable front passenger seat), model 907.6 with code SF1 (Electrically adjustable driver's seat) with code SF2 (Electrically adjustable front passenger seat)
			AR54.21-D-0015TS
		Under the "Control unit adaptations" menu item follow the instructions for "SCN coding".

CARGO RETAINERS