LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2021 >> Sprinter 1500 Van Cargo >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Electrical System, Equipment & Instructions - Removal & Installation (5 Of 8)) >> Removal & Installation >> Code Common Powertrain Controller (CPC) Control Unit (Code: Vs3WART9XX, Acc. No.: 00 902 55) - SM54.21-D-0174SG

Code Common Powertrain Controller (CPC) Control Unit (Code: Vs3WART9XX, Acc. No.: 00 902 55) - SM54.21-D-0174SG

Model 907 

Operation no. of the operation texts or standard texts and flat rates
Category Op. no. Operation text Time Acc. no. Code
L 02 2443 Operations: Connect/disconnect vehicle diagnosis system - 00 902 55 VS3WART9XX
L 02 2445 Operations: Connect/disconnect charger (vehicle diagnosis system connected) - 00 902 55 VS3WART9XX
L 02 2444 Operations: Perform SCN coding in control unit (vehicle diagnosis system connected) - 00 902 55 VS3WART9XX
  Notes on SCN coding of control units   AH54.21-P-0004-01X
INSPECT Check     
1 Check whether vehicle is affected by measure. IMPORTANT For authorized Mercedes-Benz service partners, only the entry in the "Extended VEGA Application" (EVA) system, in the "Current" tab, is decisive. An additional test of the affected vehicles in the workshop information system (WIS) or vehicle list is thereby not necessary.  
  SCN coding    
2 Connect diagnostic system.    
REFER TO SELF-DIAGNOSTIC SYSTEMS     AD00.00-D-2000-06TS
3 Connect charging equipment.    
REFER TO TESTING & REPAIR Maintaining on-board electrical system voltage when performing test and diagnosis work on vehicle NOTES
During the entire work procedure a sufficiently large voltage supply must be provided for the vehicle's on-board electrical system.
Otherwise any undervoltage that occurs may damage the control units.
IMPORTANT Follow the operating instructions for the charger.
IMPORTANT Use the charger to ensure that an adequate power supply (min. 12.5 V) is provided for the on-board electrical system battery.
AR54.10-D-1127TS
4 Update SCN coding of powertrain control unit (Common Powertrain Controller (CPC)). IMPORTANT The maintenance interval is increased in the powertrain control unit from 30,000 km to 40,000 km.
IMPORTANT The maintenance interval is recoded from code JI5 (Maintenance interval starting distance 30,000 km) to code JI6 (Maintenance interval starting distance 40,000 km) in the powertrain control unit.
IMPORTANT It is absolutely essential to precisely follow the operation steps as described in the vehicle diagnosis system.
 
5 Disconnect diagnostic system.    
REFER TO SELF-DIAGNOSTIC SYSTEMS     AD00.00-D-2000-06TS
6 Remove charger from vehicle.    
REFER TO TESTING & REPAIR     AR54.10-D-1127TS