Remove/Install TV Antenna Amplifier - AR82.62-P-8302LF
Model 217.3, 222
with code 865 (digital TV)
Shown on MODEL 222 with CODE 413 (Panoramic sliding roof)
Fig 1: TV Antenna Amplifier Component Location - Model 217.3 With Code 865 (Shown On Model 222 With Code 413)
Shown on MODEL 222 with CODE 413 (Panoramic sliding roof)
| Topical note | Notes on preventing damage to electronic components due to a magnetic tool | AH54.00-P-0002-01A | |
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Remove/install TV 2 and DAB Band III antenna amplifier (A94/2) | |||
| 1.1 | Remove headliner service flap (7) | Model 222.0/1 with code 413 (Automatic panoramic sliding sunroof) with code 865 (digital TV) Model 222.9 with code 865 (digital TV) except code Z07 (Top protection) |
|
| 1.2 | Remove headliner | Model 217.3 with code 865 (digital TV) Model 222.0/1 with code 865 (digital TV) except code 413 (Automatic panoramic sliding sunroof) |
|
| Model 222.1 with code 865 (digital TV) except code 413 (Automatic panoramic sliding sunroof) |
AR68.30-P-4300LFN | ||
| Model 222.0 with code 865 (digital TV) except code 413 (Automatic panoramic sliding sunroof) |
AR68.30-P-4300LF | ||
| Model 217.3 with code 865 (digital TV) |
AR68.30-P-4300LC | ||
| 1.3 | Remove rear section of roof lining | Model 222.9 with code 865 (digital TV) with code Z07 (Top protection) |
AR68.30-P-4307LFS |
| 2 | Disconnect electrical connection (6) | Avoid strain relief on electrical lines. Otherwise, the contact bars may be damaged. |
|
| 3 | Loosen bolt (5) | ||
| 4 | Unclip and remove the TV 2 and DAB Band III antenna amplifier (A94/2) | ||
| 5 | Install in the reverse order | ||
| Remove/install TV 1 antenna amplifier (A94/1) | |||
| 6 | Remove right cover from C-pillar | Model 222.0/1 with code 865 (digital TV) |
AR68.30-P-4490LF |
| Model 222.9 with code 865 (digital TV) |
AR68.30-P-4490LFA | ||
| Model 217.3 with code 865 (digital TV) |
AR68.30-P-4490LC | ||
| 7 | Disconnect electrical connections (4) | Avoid strain relief on electrical lines. Otherwise, the contact bars may be damaged. |
|
| 8 | Loosen screw/bolt (3) | ||
| 9 | Unclip and remove the TV 1 (A94/1) antenna amplifier | ||
| 10 | Install in the reverse order | ||
| Remove/install TV 3 antenna amplifier (A94/3) | |||
| 11.1 | Remove left cover from A-pillar | Model 222 with code 865 (digital TV) |
AR68.30-P-4050LF |
| 11.2 | Remove right-hand paneling from A-pillar | Model 217.3 with code 865 (digital TV) |
AR68.30-P-4490LC |
| 12 | Disconnect electrical connections from TV 3 antenna amplifier (A94/3) | Avoid strain relief on electrical lines. Otherwise, the contact bars may be damaged. |
|
| 13 | Loosen screw/bolt (3) | ||
| 14 | Unclip and remove the TV 3 (A94/3) antenna amplifier | ||
| 15 | Install in the reverse order |