Remove/Install Front Seat Belt - AR91.40-P-1010S
Model 223
| Risk of injury during testing and repair operations related to pyrotechnical components | Do not expose pyrotechnical component parts to temperatures above 100°c or 212°F. Disconnect current supply when working on such component parts. | AS91.00-Z-0008-01A | |
| Risk of injury . Injury may result when the tension in the spring in the automatic belt retractor is released. | Never disassemble automatic belt retractors. | AS91.00-Z-0002-01A | |
| Notice | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Information, assessment and legal requirements when working with, handling and storing pyrotechnical components | AH91.00-Z-0000-10A | ||
| Remove/install | |||
| 1 | Remove trim on B-pillar. | Model 223 except code Z07 (B7 armoring on special protection version) |
AR68.30-P-4700S |
| 2 | Disconnect ground line of battery of 12 V onboard electrical system. | AR54.10-P-0051S | |
| 3 | Release catch hooks (2) of guide (1) and remove guide (1). | ||
| 4 | Remove nut (4) and push air duct (3) to one side. | ||
| 5 | Remove screw (5) and remove seat belt guide bracket (6) from seat belt height adjustment (7). | *BA91.40-P-1005-01T | |
| 6 | Disconnect electrical connector (8). | Fig 1 | |
| 7 | Release and disconnect electrical connector (9) from front reversible belt tensioner (A76, A76/1). | ||
| 8 | Disconnect electrical connector (10). | ||
| 9 | Unclip electrical wiring harness (13) from holder (14). | Fig 2 | |
| 10 | Remove screw (11). | *BA91.40-P-1004-01T | |
| 11 | Remove bolt (12). | *BA91.40-P-1004-01T | |
| 12 | Remove front reversible belt tensioner (A76, A76/1) with seat belt. | ||
| 13 | Install in the reverse order. | ||
| 14 | Check Supplemental Restraint System (SRS) with diagnostic device. | ||
| AD00.00-P-2000-06FR | |||
| 15 | Check seat belt slack reduction for proper operation. | If the seat belt slack reduction function is not activated in the instrument cluster, ↓ activate the function in the instrument cluster. |
SEAT BELTS AND EMERGENCY TENSIONING RETRACTORS
| Number | Designation | Model 223 with code Z07 (B7 armoring on special protection version) | Model 223 except code Z07 (B7 armoring on special protection version) |
|
|---|---|---|---|---|
| BA91.40-P-1004-01T | Screw, front belt retractor | Nm | 35 | 35 |
SEAT BELTS AND EMERGENCY TENSIONING RETRACTORS
| Number | Designation | Model 223 with code Z07 (B7 armoring on special protection version) |
Model 223 except code Z07 (B7 armoring on special protection version) |
|
|---|---|---|---|---|
| BA91.40-P-1005-01T | Bolt at front belt guide bracket | Nm | 35 | 35 |