Outer Rear Wheel Well Removal - Ar63.10-P-0660-01S

Model 223.0/1/9 

The next steps are shown on the left side of the vehicle for model 223.1 and must be performed in the same way on the right side of the vehicle in the event of damage.

The superordinate service document as well as the safety information in the service document must be observed.

Courtesy of MERCEDES-BENZ USA

1. Mark separating points on outer rear wheel well (1) and cut (areas A).

   Do not make the cuts too deep.

   Otherwise the components behind can be damaged and weakened.

   Dimensions: 

   a = approx. 25 mm

   Courtesy of MERCEDES-BENZ USA

2. Expose spot welds on outer rear wheel well (1) and cut out (areas B).
3. Bend open sheet metal lug in direction of arrow.

   Courtesy of MERCEDES-BENZ USA

4. Heat outer rear wheel well (1) in cross-hatched areas.

   Cross-hatched areas are bonded with adhesive.

5. Remove outer rear wheel well (1).

   Courtesy of MERCEDES-BENZ USA

6. Grind mating surfaces down to bare metal in cross-hatched areas.

   Observe pretreatment of bonding surfaces.

7. Remove grinding dust.