Remove/Install Rear Roller Sun Blind On Panoramic Sliding Roof - AR77.21-P-0203S
Model 223
with code 413 (Panoramic sliding sunroof/glass roof)
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Remove/install | |||
| 1 | Remove roof lining and place in vehicle. | AR68.30-P-4300S | |
| Model 223 with code 413 (Panoramic sliding sunroof/glass roof) except code Z07 (B7 armoring on special protection version) |
|||
| 2 | Disconnect electrical connector (7). | ||
| 3 | Remove electrical wiring harness (8) from sliding sunroof segment (3) and right guide rail (2). | ||
| 4 | Remove screws (4, 5, 6). | ||
| 5 | Remove roller sunblind (1) together with sliding sunroof frame segment (3), roller sunblind motor (M54/1) and guide rails (2) and remove from vehicle. | ||
| 6 | Remove screws (9). | When replacing roller sun blind (1). | |
| 7 | Remove sliding sunroof frame segment (3) with roller sunblind motor (M54/1) and guide rails (2) from roller sunblind (1). | When replacing roller sun blind (1). | |
| 8 | Install in the reverse order. |