Remove/Install Rear Wall Paneling - AR68.30-P-4750S

Model 223 

except code Z07 (B7 armoring on special protection version) 

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Notes on HANDS-FREE ACCESS		AH80.61-P-0001-01A
	Remove/install
1	Open trunk lid.
2	Remove refrigerator box.	Model 223 with code 308 (Refrigerated compartment in rear passenger compartment) except code Z07 (B7 armoring on special protection version)
3	Remove trunk floor (3).	Model 223 except code ME10 (Hybrid vehicle (plug-in, PHEV)) except code Z07 (B7 armoring on special protection version)
4	Unclip expansion rivets (1).	Dismantling tool	Fig 1
5	Unclip and remove rear panel trim (2).	Make sure that the retaining clips are seated correctly.
		Long wedge	Fig 2
6	Install in the reverse order.

Fig 1: Identifying Dismantling Tool (000 589 95 63 00)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Long Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ USA