Remove/Install Seat Belt Guide - AR91.45-P-0500SA

Model 223

with code 223 (Electric backrest adjustment and head restraints)

with code 224 (Individual rear seats)

with code U07 (Seat belt extender in rear passenger compartment)

Model 223

with code 223 (Electric backrest adjustment and head restraints)

with code U07 (Seat belt extender in rear passenger compartment)

except code 224 (Individual rear seats)

Courtesy of MERCEDES-BENZ USA

Shown on left seat belt guide (1)

Courtesy of MERCEDES-BENZ USA

Shown on left seat belt guide (1)

Courtesy of MERCEDES-BENZ USA

	Remove
1	Fully grip corresponding seat belt guide (1) by hand and carefully pull out without bending seat belt feeder arm (2) until engagement (1.1) of seat belt guide (1) is accessible.	Bracket (1.2) of seat belt guide (1) must not be opened if seat belt guide (1) is reused. Otherwise, seat belt guide (1) must be replaced, since correct engagement (arrows B) cannot be guaranteed.
2	Release engagement (1.1) and pull seat belt guide (1) out of seat belt feeder arm (2).	Extraction hook	Fig 1
3	Pull out seat belt feeder arm (2).	Pay attention to angle of seat belt feeder arm (2) when pulling out.
4	Unclip trim ring (3) through opening in center using extraction hook at side (arrows A) and remove.	Extraction hook	Fig 1
5	Release engagement (arrows B) by pulling bracket (1.2) upward, open bracket (1.2) and guide out seat belt.	If seat belt guide (1) is replaced.
	Install
6	Place seat belt into new seat belt guide (1) and insert bracket (1.2) in direction of arrow C until it engages.	If seat belt guide (1) has been replaced.
7	Close bracket (1.2) on inside and press in catch (1.3).	If seat belt guide (1) has been replaced. Ensure that bracket (1.2) engages (arrows B) and is correctly seated. There must not be any visible gap between bracket (1.2) and remaining seat belt guide (1). Ensure that catch (1.3) engages.
8	Insert trim ring (3).	Ensure that trim ring (3) engages.
9	Carefully insert seat belt feeder arm (2).	Position seat belt feeder arm (2) at same angle as it was pulled out and insert. Otherwise, seat belt feeder arm (2) may break.
10	Insert seat belt guide (1) into seat belt feeder arm (2) until latching (1.1) engages.
11	Continue to insert seat belt guide (1) with seat belt feeder arm (2) until seat belt guide (1) protrudes around 2 to 3 cm from trim ring (3).

Fig 1: Identifying Extraction Hook (140 589 02 33 00)

Courtesy of MERCEDES-BENZ USA