Remove/Install Cap For Armrest Of Center Console In Rear Passenger Compartment - AR68.20-P-2371S

Model 223 

with code 224 (Individual rear seats) 

Courtesy of MERCEDES-BENZ USA

Shown on model 223 with code 447 (Touchscreen rear) and with code 907 (Rear armrest heater) 

Notice	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Remove/install
1	Remove tablet PC (A105/7) from tablet cradle electric controller unit (A105/6).	Model 223 with code 224 (Individual rear seats) with code 447 (Touchscreen in rear)
2	Switch off ignition and store transmitter key outside of transmission range (min. 2 m).
3	Remove stowage box at top in rear (2).		AR68.20-P-0007S
4	Release and disconnect electrical connection (3).
5	Release and disconnect electrical connector (4).	Model 223 with code 224 (Individual rear seats) with code 907 (Rear armrest heater)
6	Open up cover for armrest (1).
7	Raise folding tables.	Model 223 with code 224 (Individual rear seats) with code 449 (Folding table in the rear, left and right)
8	Unclip cover (5), as shown, at top.	Long wedge	Fig 1
9	Remove screws (6).
10	Remove cover for armrest (1).
11	Install in the reverse order.

Fig 1: Identifying Long Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ USA