Remove/Install Bottom Paneling For Dashboard On Driver Side - AR68.10-P-1501S

Model 223 

MODIFICATION NOTES

27.09.2022

New operation step added.

Operation step 6.

Courtesy of MERCEDES-BENZ USA

Notice	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Remove/install
1	Move driver's seat to rearmost end position.
2	Switch off ignition and store transmitter key outside of transmission range (min. 2 m).
3	Remove screws (1).
4	Lower trim (2) (arrow) until electrical connectors (3, 4, 5, 6) can be accessed.	The number can vary according to the equipment.
		Long wedge	Fig 1
5	Release and disconnect electrical connectors (3,	The number can vary according to the equipment.
6	Unscrew screw at engine hood release handle (7).
7	Release engine hood release handle (7) and remove toward rear out of trim (2).
8	Detach trim (2) at rear at floor covering and remove.
9	Install in the reverse order.

Fig 1: Identifying Long Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ USA