Remove/Install Armrest Heater Control Unit - AR68.20-P-0004S
Model 223
with code 906 (Front armrest heater)
Model 223
with code 907 (Rear armrest heater)
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Notice | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notes on HANDS-FREE ACCESS | AH80.61-P-0001-01A | ||
| Remove/install | |||
| 1 | Switch off ignition and store transmitter key outside of transmission range (min. 2 m). | ||
| 2 | Remove left side trunk lining. | AR68.30-P-4800SG | |
| Model 223 with code 906 (Front armrest heater) with code Z07 (B7 armoring on special protection version) Model 223 with code 907 (Rear armrest heater) with code Z07 (B7 armoring on special protection version) |
|||
| Model 223 with code 906 (Front armrest heater) except code Z07 (B7 armoring on special protection version) Model 223 with code 907 (Rear armrest heater) except code Z07 (B7 armoring on special protection version) |
AR68.30-P-4800S | ||
| 3 | Remove subwoofer in trunk. | Model 223 with code 811 (High-End sound system) with code 906 (Front armrest heater) Model 223 with code 811 (High-End sound system) with code 907 (Rear armrest heater) |
|
| AR82.62-P-7841S | |||
| 4 | Disconnect electrical connectors (1) at trunk lid control unit and remove associated wiring harness. | Model 223 with code 881 (Remote boot-lid closing) with code 906 (Front armrest heater) Model 223 with code 881 (Remote boot-lid closing) with code 907 (Rear armrest heater) |
|
| 5 | Remove bracket (2) and place with installed control units to one side. | ||
| 6 | Disconnect electrical connector (3). | ||
| 7 | Remove armrest heater control unit (N5). | ||
| 8 | Install in the reverse order. | ||
| 9 | Perform commissioning of armrest heater control unit (N5). | When replacing the armrest heater control unit (N5). | |
| AD00.00-P-2000-06FR | |||
| Normalizing | |||
| 10 | Close trunk lid manually. | Model 223 with code 881 (Remote boot-lid closing) with code 906 (Front armrest heater) Model 223 with code 881 (Remote boot-lid closing) with code 907 (Rear armrest heater) |
|
| 11 | Actuate driver trunk lid control button in driver's door trim in "Open" position until trunk lid reaches upper stop. | Model 223 with code 881 (Remote boot-lid closing) with code 906 (Front armrest heater) Model 223 with code 881 (Remote boot-lid closing) with code 907 (Rear armrest heater) |
|
| 12 | Actuate driver trunk lid control button in driver's door trim again for 4 s in 'Open' position. | Model 223 with code 881 (Remote boot-lid closing) with code 906 (Front armrest heater) Model 223 with code 881 (Remote boot-lid closing) with code 907 (Rear armrest heater) |