Remove/Install Stolen Vehicle Tracking Energy Management Control Unit - AR54.10-P-0058S
Model 223
with code 830 (China version)
Fig 1: Stolen Vehicle Tracking Energy Management Control Unit Components Location - Model 223 With Code 830
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Notice | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notes on HANDS-FREE ACCESS | AH80.61-P-0001-01A | ||
| Remove/install | |||
| 1 | Switch off ignition and store transmitter key outside of transmitter range (min. 2 m). |
||
| 2 | Remove rear-end center-section trim. | AR68.30-P-4786S | |
| 3 | Remove trunk floor (1). | Fig 2 | |
| 4 | Release and disconnect electrical connector (2). | ||
| 5 | Remove buffer battery management system control unit (N178). | ||
| 6 | Install in the reverse order. | ||
| Finishing activity | |||
| 7 | Commission buffer battery management system control unit (N178). | ||
| AD00.00-P-2000-06FR |