Remove/Install Rear SAM Control Unit - AR54.21-P-1269S
Model 223
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Notice | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notes on HANDS-FREE ACCESS | AH80.61-P-0001-01A | ||
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Remove/install | |||
| 1 | Switch off ignition and store transmitter key outside of transmission range (min. 2 m). | ||
| 2 | Remove side trim at right in trunk. | AR68.30-P-4800SG | |
| Model 223 with code Z07 (B7 armoring on special protection version) |
|||
| Model 223 except code Z07 (B7 armoring on special protection version) |
AR68.30-P-4800S | ||
| 3 | Remove bracket (1) and place to one side. | ||
| 4 | Release and disconnect electrical connectors from rear signal acquisition and actuation module control unit (N10/8). | ||
| 5 | Unscrew screw (2) and remove rear signal acquisition and actuation module control unit (N10/8) from bracket (1). | ||
| 6 | Install in the reverse order. | ||
| 7 | Commission rear signal acquisition and actuation module control unit (N10/8). | When replacing the rear signal acquisition and actuation module control unit (N10/8). | |
| AD00.00-P-2000-06FR |