Remove/Install Current Limiter Module - AR54.10-P-1404S
Model 223
with code ME10 (Hybrid vehicle (plug-in, PHEV))
| Notice | General information on vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system as well as personal protective equipment | AH00.00-Z-0300-01A | |
| Notice | Notes on self-locking nuts and bolts | AH00.00-P-0001-01KOA | |
| Notice | Notes on battery | AH54.10-P-0001-01A | |
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Remove/install | |||
| 1 | Disconnect the ground line for the on-board electrical system battery (G1). | AR54.10-P-0051S | |
| 2 | Remove strut (1). | *BA62.30-P-1009-02P | |
| *BA62.30-P-1008-02P | |||
| 3 | Remove cover over positive line (2). | ||
| 4 | Unscrew nut (3), remove electric line and place to one side. | *BA54.10-P-1013-01N | |
| 5 | Unscrew nut (4), remove electric line and place to one side. | *BA54.10-P-1013-01N | |
| 6 | Detach nut (5) at positive terminal of on-board electrical system battery (G1) and remove current limiter module (N16/3) until electrical connectors (6) and electric line (7) are accessible. | ||
| *BA54.10-P-1008-01N | |||
| 7 | Open cover (8) and remove electric line (7). | *BA54.10-P-1013-01N | |
| 8 | Release and disconnect electrical connector (6) and remove current limiter module (N16/3). | ||
| 9 | Install in the reverse order. |
BATTERY
| Number | Designation | Model 223 except code Z07 | Model 223 with code Z07 | |
|---|---|---|---|---|
| BA54.10-P-1008-01N | Nut, charging cable to negative terminal/positive terminal of on-board electrical system battery | Nm | 6 | 6 |
BATTERY
| Number | Designation | Model 223 except code Z07 | Model 223 with code Z07 | |
|---|---|---|---|---|
| BA54.10-P-1013-01N | Nut, positive line/ground line to DC/DC converter control unit/on-board electrical system battery (48 Volt)/voltage dip limiter/current limiting module | Nm | 16 | 16 |
FRONT AREA WITH FRONT REINFORCEMENT
| Number | Designation | Model 223 | |||
|---|---|---|---|---|---|
| BA62.30-P-1008-02P | Screw, center/lower strut to suspension strut tower mounting console | Stage 1 | Nm | 35 | |
| Stage 2 | Nm | 50 | |||
| Stage 3 | Loosen | ∠° | 180 | ||
| Stage 4 | Nm | 50 | |||
FRONT AREA WITH FRONT REINFORCEMENT
| Number | Designation | Model 223 | |
|---|---|---|---|
| BA62.30-P-1009-02P | Screw, center strut to longitudinal member mounting console | Nm | 30 |