Remove/Install 360 Degree Camera In Outside Mirror - AR54.65-P-3002S
Model 223
with code 501 (360° camera)
Fig 1: 360 Degree Camera In Outside Mirror Components Location - Model 223 With Code 501(Shown On Left Side)
Shown on left outside mirror
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Remove/install | |||
| 1 | Switch off ignition and store transmitter key outside of transmission range (min. 2 m). | ||
| 2 | Remove upper cover of relevant outside mirror. | Model 223 with code 501 (360° camera) |
|
| Model 223.0/1 with code 501 (360° camera) |
AR88.70-P-9040S | ||
| 3 | Disconnect electrical connector (1). | ||
| 4 | Remove bolts (2). | ||
| 5 | Release retaining tabs (arrows A) and remove holder of outside mirror 360 degree camera (3). | ||
| 6 | Remove outside mirror 360 degree camera (3). | ||
| 7 | Install in the reverse order. | ||
| 8 | Calibrate outside mirror 360 degree camera (3) using vehicle diagnosis system. | ||
| AD00.00-P-2000-06FR |