Remove/Install 360° Camera In Outside Mirror - AR54.30-P-3002LF
Model 217, 222
with code 501 (360° camera)
MODIFICATION NOTES
| 21.8.15 | Commissioning of left outside mirror 360° camera or right outside mirror 360° camera using diagnostic system added. | Operation step 7 |
Shown on model 222, right outside mirror
Fig 1: 360° Camera (Outside Mirror) Component Location - Model 217 With Code 501 (Shown On Model 222)
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1 | Switch off ignition and remove transmitter key | ||
| 2 | Remove outside mirror trim | AR88.70-P-9040LF | |
| 3 | Remove bolts (1) | ||
| 4 | Disconnect electrical connector (2) and remove camera module | ||
| 5 | Release retaining lugs (3) and remove 360° camera for left outside mirror (B84/7) or 360° camera for right outside mirror (B84/8) | ||
| 6 | Install in the reverse order | ||
| 7 | Commission left outside mirror 360° camera (B84/7) or right outside mirror 360° camera (B84/8) using diagnostic system | If the camera for the left outside mirror 360° camera (B84/7) or the camera for the right outside mirror 360° camera (B84/8) was replaced. | |
| AD00.00-P-2000-04B | |||
| 8.1 | Calibrate camera for left outside mirror 360° camera (B84/7) or camera for right outside mirror 360° camera (B84/8) using diagnostic system | If the camera for the left outside mirror 360° camera (B84/7) or the camera for the right outside mirror 360° camera (B84/8) was removed. | |
| AD00.00-P-2000-04B | |||
| 8.2 | Calibrate all the cameras for the 360° camera system using the diagnostic system | If the camera for the left outside mirror 360° camera (B84/7) and the camera for the right outside mirror 360° camera (B84/8) were removed. | |
| AD00.00-P-2000-04B |