Install Longitudinal Member Front Section - Ar62.20-P-1260-20LF
Model 217, 222
The following operation steps are shown on the left side of the vehicle on model 222 and must be performed in the same way on the right side in the event of damage.
- Install, align and fix longitudinal member front section (1) in place using straightening tool.
- Install mounting console (3), fit and fix in place.
- Drill Ø 6.7 mm rivet holes in mounting consoles (3).
- Remove mounting supports (3), straightener and longitudinal member front section (1).
- Deburr rivet holes on longitudinal member front section (1), mounting consoles (3) and body on both sides.
- Install longitudinal member front section (1) with straightening tool.
- Apply 2-component adhesive to body and longitudinal member front section (1) in crosshatched areas.
Observe pretreatment of bonding surfaces and manufacturer's specifications for drying and processing time of 2-component adhesive.
- Install mounting consoles (3).
- Rivet longitudinal member (front section) (1) and mounting consoles (3) with Ø 6.4 rivet M6 (areas A).
- Mark position of threaded pin M6x13 (arrow).
b = approx. 200 mm
c = approx. 35 mm
- Drill threaded holes with Ø 5 mm bit in mounting console (3) and longitudinal member front section (1) (arrow).
- Cut thread M6 in mounting support (3) and longitudinal member front section (1) (arrow).
- Coat threaded pin M6x13 with Loctite 241 and screw in (arrow).