Remove/Install Stabilizer Bar On Front Axle - AR32.20-P-0300LC

Model 217 

except code 487 (Active Body Control (ABC)) 

Shown on MODEL 222 with CODE M005 (4MATIC) 

Courtesy of MERCEDES-BENZ USA

Courtesy of MERCEDES-BENZ USA

Courtesy of MERCEDES-BENZ USA

Shown on model 217.4 

Courtesy of MERCEDES-BENZ USA

	Notes on self-locking nuts and bolts		AH00.00-P-0001-01KOA
	Notes on AIRmatic		AH32.22-P-1000-02LF
	Notes on repair work on suspension components		AH00.00-P-0100-01A
	Remove/install
1	Remove front complete wheels		AR40.10-P-1102A
2	Empty suspension struts using diagnostic system
			AD00.00-P-2000-04B
3	Detach engine compartment paneling		AR61.20-P-1105LF
4	Remove front diagonal struts (32)	Model 217.4 except code 487 (Active Body Control (ABC)) Screw/bolt, front diagonal strut to front axle carrier/body	*BA61.10-P-1018-01K
5	Unscrew nuts (1) at both ends of torsion bar linkage (2) from torsion bar (3)	Turn steering in corresponding direction.	AR32.35-P-3328LF
		Nut, torsion bar linkage to torsion bar	*BA32.20-P-1001-02O
6	Detach suspension struts at front from lower control arms and push to one side		AR32.25-P-1017LFB
7	Unscrew bolts (4) on both sides and remove retaining brackets (5) on both sides	Bolt, torsion bar to front axle carrier	*BA32.20-P-1003-02O
8	Turn steering a half turn to the left	The markings on the steering shaft (arrows) must be offset by 180°.
9	Remove torsion bar (3)	: First thread the torsion bar (3) into the torsion bar linkage (2).
10	Install in the reverse order