Remove/Install Rear Seat Belts - AR91.40-P-0681LC
MODEL 217.3
Shown on right side of vehicle
| Risk of injury caused by performing testing or repair work on airbag or emergency tensioning retractor units. | Store airbag units with deployment side facing up; do not expose to temperatures greater than 100°C. When working on these units, disconnect the power supply. | AS91.00-Z-0001-01A | |
| Risk of injury . Injury may result when the tension in the spring in the automatic belt retractor is released. | Never disassemble automatic belt retractors. | AS91.00-Z-0002-01A | |
| Notes on performing repair, body work and welding on vehicles with airbags and RTE units | AH91.00-P-0002-01M | ||
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Assessment of airbag and belt tensioner units in accident vehicles | AH91.00-P-0006-01B | ||
| Legal requirements on handling and storing airbags and emergency tensioning retractor units | AH91.00-P-0004-01A | ||
| Remove/install | |||
| 1 | Remove front part of rear shelf | AR68.30-P-4581LC | |
| 2 | Remove lower side paneling in rear | AR68.30-P-4780LC | |
| 3 | Remove screw/bolt (3) from seat belt (1) | *BA91.40-P-1009-01V | |
| 4 | Push off soundproofing (arrows b, c) upwards | ||
| 5 | Disconnect electrical connector (4) from seat belt retractor (2) | ||
| 6 | Remove screw/bolt (5) from seat belt retractor (2) | *BA91.40-P-1008-01V | |
| 7 | Twist seat belt retractor (2) and remove from above | When replacing belt retractor (2) ↓ Dispose of the seat belt retractor (2) properly. |
|
| 8 | Install in the reverse order | ||
| 9 | Connect diagnostic system and check supplemental restraint system (SRS) | When replacing belt retractor (2) | |
| AD00.00-P-2000-04B |
SEAT BELTS
| Number | Designation | MODEL 217 | |
|---|---|---|---|
| BA91.40-P-1008-01V | Bolt, rear seat belt retractor to rear panel | Nm | 35 |
SEAT BELTS
| Number | Designation | MODEL 217 | |
|---|---|---|---|
| BA91.40-P-1009-01V | Bolt, rear belt end fitting to longitudinal member | Nm | 35 |