Remove/Install Front Passenger Knee Airbag - AR91.60-P-0100LC
Model 217
with code 494 (US version)
| Risk of injury during testing and repair operations related to pyrotechnical components | Do not expose pyrotechnical component parts to temperatures above 100°C or 212°F. Disconnect current supply when working on such component parts. | AS91.00-Z-0008-01A | |
| Topical note | Notes on performing repair, body work and welding on vehicles with airbags and RTE units | AH91.00-P-0002-01M | |
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Information, assessment and legal requirements when working with, handling and storing pyrotechnical components | AH91.00-Z-0000-10A | ||
| Legal requirements on handling and storing airbags and emergency tensioning retractor units | AH91.00-P-0004-01A | ||
| Remove/install | |||
| 1 | Move front passenger seat toward rear | ||
| 2 | Disconnect battery ground line | AR54.10-P-0003LF | |
| 3 | Remove bolts (2) | *BA91.60-P-1003-01I | |
| 4 | Remove front passenger kneebag (1) until the electrical connector for the front passenger kneebag squib is accessible | ||
| 5 | Disconnect electrical connector from front passenger kneebag squib | ||
| 6 | Remove front passenger kneebag (1) | ||
| 7 | Dispose of removed front passenger kneebag (1) properly | When replacing front passenger kneebag (1). | |
| 8 | Install in the reverse order | ||
| 9 | Connect diagnostic system and check supplemental restraint system (SRS) | ||
| AD00.00-P-2000-04B |
AIRBAG
| Number | Designation | Model 217 | |
|---|---|---|---|
| BA91.60-P-1003-01I | Bolt, knee airbag to footwell cover | Nm | 5 |