Retrofit Holder For CA Module Card Reader - AZ82.60-P-0032-02LC

Model 217.3 

except code 811 (High-End sound system) 

1. Use tape to mask off the area where the bracket for the CA module card reader is to be fastened to the trunk recess cover (2).
2. Mark hole location (arrow A).

   Dimensions:

   1. 40 mm
   2. 220 mm

   Courtesy of MERCEDES-BENZ USA

3. Place Velcro strip (3) at previously marked hole location (arrow A), align and mark remaining hole locations as indicated by the Velcro strip (3).

   The Velcro strip (3) must be aligned at a right angle to the reference edge (arrow B).

4. Remove Velcro strip (3).
5. Drill holes of 6 mm Ø at the marked hole locations.

   Courtesy of MERCEDES-BENZ USA

6. Fasten Velcro strip (3) with the expansion rivets (4) to the trunk recess cover (2).

   Use expansion rivets (4) with a Ø of 6 mm. The expansion rivets (4) are included in the scope of supply.

   Courtesy of MERCEDES-BENZ USA

7. Fasten CA module card reader (1) to trunk recess cover (2) using Velcro strip (3).
8. Mark location of hole (arrow C) for inserting electrical wiring harness for CA module card reader (1).
9. Remove CA module card reader (1).
10. Drill 6 mm Ø hole at marked hole location (arrow C).

    Courtesy of MERCEDES-BENZ USA

11. Make cuts (dashed lines) approx. 4 mm in length at four points at the previously drilled hole (arrow C).

    Courtesy of MERCEDES-BENZ USA