Retrofit Electrical Wiring Harness For CA Module Card Reader - AZ82.60-P-0032-01LC
Model 217.3
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notes on HANDS-FREE ACCESS | AH80.61-P-0001-01A |
except code 811 (High-End sound system)
- Prepare contacting for blue 1-pole connector (5.1) at tuner unit (A90/4).
- Lay and fix wiring set (5) to installation location of card reader CA-module.
Observe excessive length of wiring set (5) for contacting on card reader CA-module.
The blue 1-pole connector (5.2) is connected to the card reader CA-module later.