Remove Pilot Bushing - AR41.10-P-0250-02LF

MODEL 217 

MODEL 222 

Measure 

1. Measure and note dimension (a).

   Courtesy of MERCEDES-BENZ USA

   Remove 

2. 1. Knock pilot bushing (10) using flat chisel uniformly onto drive shaft (arrow).

      If the pilot bushings (10) are not seized.

      If the pilot bushings (10) are seized.

   2. 15 mm from the end face of the pilot bushing (10), drill a hole (Ø 10 mm) at right angles through the centering sleeve (10).

   Courtesy of MERCEDES-BENZ USA

   Courtesy of MERCEDES-BENZ USA

3. Insert drift through hole and pry pilot bushing (10) out of drive shaft using two assembly levers.

   If the pilot bushings (10) are seized.

Courtesy of MERCEDES-BENZ USA