Wiring Diagram Brake Wear Indicator - PE43.00-P-2200-97SEA
Model 217, 222 as of model year 2018
Brake wear sensors S10/2 and S10/4
| Code: | Designation: | Position: |
|---|---|---|
| A0 | Use of wiring diagrams | 23L |
| Code F217 | MODEL SERIES 217 | 17E |
| Code F222 | MODEL SERIES 222 | 4E |
| Code F222 | MODEL SERIES 222 | 15E |
| Code FA | CABRIOLET | 9E |
| Code FC | COUPE | 6E |
| Code L | LEFT-HAND DRIVE | 7F |
| Code L | LEFT-HAND DRIVE | 9F |
| Code R | RIGHT-HAND DRIVE | 7F |
| Code R | RIGHT-HAND DRIVE | 9F |
| N10/6 | Front SAM control unit | 3A |
| N10/8 | Rear SAM control unit | 13A |
| S10/2 | Right front brake wear sensor | 3L |
| S10/2x1 | Right front brake wear sensor electrical connector | 2J |
| S10/4 | Right rear brake wear sensor | 14L |
| S10/4x1 | Right rear brake wear sensor electrical connector | 13J |
| W54/5 | Right rear wheel well ground point | 19L |
| W7 | Right wheelhouse trunk ground point | 16L |
| W85/1 | Driver footwell frame floor assembly ground point | 10L |
| W85/1 | Driver footwell frame floor assembly ground point | 6L |
| W85/1 | Driver footwell frame floor assembly ground point | 8L |
| W85/2 | Front passenger footwell frame floor assembly ground point | 10L |
| W85/2 | Front passenger footwell frame floor assembly ground point | 8L |
| X18/7 | Vehicle interior and engine compartment electrical connector | 2E |
| X62/33 | Rear axle electrical connector, right distributor | 13H |
| X62/6 | Front axle electrical connector, right distributor | 2H |
| Z1z1 | Connector sleeve 2 in wiring harness | 8G |
| Z1z13 | Circuit 31 connector sleeve | 16G |
| Z1z2 | Circuit 31 connector sleeve | 8H |
| Z1z9 | Circuit 31 connector sleeve | 5G |