Apply Adhesive Material - AR67.10-P-1000-08P
Model 117, 129, 140, 156, 168, 169, 170, 171, 172.4, 176, 190, 197, 202, 203, 204, 205, 207, 208, 209, 210, 212, 213, 215, 217, 218, 230.4, 231, 238, 242, 245.2, 246, 253, 292, 293, 414.700
Model 211
except code Z04 (Light armoring)
Model 220
except code Z04 (Light armoring)
except code Z07 (B7 armoring on special protection version)
Model 222
except code Z07 (B7 armoring on special protection version)
The bonding area must be free of dust and grease.
Otherwise the adhesive force of the adhesive material (1) starts to decrease.
Only use the adhesive kit indicated in the XENTRY Portal parts information.
-
- Model 117, 129, 140, 156, 168, 169, 170, 171, 172.4, 176, 190, 197, 202, 203, 204, 205, 207, 208 (except 208.3), 209, 210, 212, 213, 215, 217, 218, 230.4, 231, 238, 242, 245.2, 246, 253, 292, 293, 414.700
Model 211
except code Z04 (Light armoring)
Model 220
except code Z04 (Light armoring)
except code Z07 (B7 armoring on special protection version)
Model 222
except code Z07 (B7 armoring on special protection version) Guide application nozzle 13 mm (2) along body flange (4) and uniformly apply adhesive material (1).
Install window (3) within 10 min of applying adhesive material (1).
Otherwise the adhesive force of the adhesive material (1) starts to decrease.
The height of the adhesive bead must be approx. 13 mm.
- Model 208.3
Guide application nozzle 16 mm (6) along profile seal (5) on inside of window (3) and uniformly apply adhesive material (1).
Otherwise the adhesive force of the adhesive material (1) starts to decrease.
- Model 117, 129, 140, 156, 168, 169, 170, 171, 172.4, 176, 190, 197, 202, 203, 204, 205, 207, 208 (except 208.3), 209, 210, 212, 213, 215, 217, 218, 230.4, 231, 238, 242, 245.2, 246, 253, 292, 293, 414.700
- Completely press out adhesive material (1) not required and dispose of.
adapter to completely press out 1-component adhesive. Insert it between the cartridge piston and the plate on the push rod of the squeeze gun.