Remove/Install Door Sill Molding - AR68.30-P-4100LC

MODEL 217 

Fig 1: Door Sill Molding Component Location - Model 217

Courtesy of MERCEDES-BENZ USA

Shown on right-hand side 

	Remove/install
1	Completely open door
2	Unclip door sill (1) upward and remove	: When installing the retaining clips (2), ensure that the retaining clips (2) are attached in the correct position. The electrical wiring harness under the door sill can otherwise be damaged. : Replace damaged retaining clips (2). Ensure that retaining clips (2) and guide lugs (1.1) are seated correctly in mounts. Mounting wedge	Fig 2
3	Install in the reverse order

Fig 2: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA